Electric bicycle use method and precautions for reference

Vehicle use method and precautions

1.. Check before driving

a. Whether the tire pressure is normal, according to the depression of the tire grounding part, determine whether the pressure is appropriate (when the pressure is abnormal, use the tire pressure gauge to check and adjust to the normal pressure, the normal pressure is 2.5-3.0kpa). Note that low tire pressure, cracking, damage, and abnormal wear can cause inflexible steering or a flat tire.

b. Whether the front and rear wheel screws are locked, the handlebars swing left and right, whether they are loose, too tight or stuck, and whether the seat cushion is adjusted properly and the lock is firm.

c. Whether the power is sufficient, headlights, turn signals, taillights, brake lights, horns, etc., are normal.

d. Whether the brake system is properly adjusted and whether it can automatically power off when braking.

e. Rearview mirror: In the driving position, the rearview mirror should be able to observe the rear within ten meters.

f. If there is any abnormality, please timely repair or stop using.

2. Driving operation method

☞ Start method

Insert the switch key into the power switch lock on the right side of the front compartment, turn clockwise, and the power display starts at this time, indicating that the power is connected. Turn counterclockwise, cut off the power and stop the motor.

☞ Headlight switch

The headlight switch is pushed to the left and the reverse light is off.

☞ Regulator

Inward, slowly turn the speed control handle counterclockwise, the vehicle begins to start the speed control Angle from small to large, and the speed is also slow to fast. Outward, rotate clockwise to slow down, relax the reset, and the motor stops rotating.

☞ horn switch

When the power is turned on, press the horn button and it will sound. Do not use it when it is not necessary or on roads where the siren is prohibited.

☞ Turn switch

When turning or changing the channel, use this switch, turn left and pull left, turn right and dial right, turn the end of the turn, put the button in the middle, and the signal light will go out.

☞ The use of brakes (brakes)

When braking, you can power off the brake by holding the brake handle straight, release the brake handle after braking, and turn the speed handle to restart.

3. Precautions on the way

★ The vehicle should be slowly accelerated when starting, so as to avoid accidental acceleration or excessive starting current waste of electric energy or damage to electrical components.

★ Under the premise of ensuring safety, economic speed should be used as far as possible during driving, and frequent braking and starting should be minimized to save energy.

★ Riding is prohibited in areas where the depth of water exceeds one third of the wheel diameter.

★ It is strictly prohibited to be overweight, and it is not allowed to ride with people on the pedal.

★ If you need to turn during driving, please turn on the corresponding turn signal.

★ It is strictly prohibited to speed, please obey the traffic rules and keep in mind the safe speed.

4. Parking precautions

◎ When you get out of the car, you should turn off the power switch to prevent unintentional rotation of the handle during the implementation, and the car suddenly starts.

◎ When parking, the power should be turned off, the key should be removed to open the anti-theft device, and anti-theft measures should be taken to avoid the loss of electric vehicles.

◎ Do not park on soft, sloping ground to prevent the car from tipping over.

◎ For your driving safety, but also so that your car can maintain the best condition, please carry out regular maintenance and cleaning.

5. Battery charging method and precautions

Battery maintenance and charger use method

◎ Battery factory transport storage for a period of time, before the first use should be sufficient electricity, when driving found insufficient power, should be replenished in time, long-term storage should be sufficient electricity once a month to avoid long-term power loss, resulting in battery vulcanization damage.

◎ Check the safety of the power supply and socket before charging, and it is prohibited to charge the power line when the installation is not standard and the line is aging.

◎ Please turn off the power when charging, take off the key, the charger should be connected to the electric vehicle charging socket before connecting to the power socket.

◎ After the power is connected, the red light of the charger is on, indicating that the power is connected and is being charged.

◎ Depending on the remaining power of the battery, the charging time is 3 to 8 hours. The green indicator of the charger lights up, indicating that the movie is full.

◎ Please use the charger that matches the vehicle battery.

◎ It is forbidden to cover any items when charging the charger. It is forbidden to store flammable and explosive items around the charger, and it is used in a well-ventilated environment.

◎ Please fully discharge the battery before charging the newly purchased electric vehicle for the first time. Under normal circumstances, the first seven charging hours are not less than 10 hours, but not more than 18 hours.

◎ The charger is used for transportation, do not violently bump or crash when carrying, otherwise it will easily cause damage to the internal parts, and prevent liquid and metal chips from entering the charger when stored to prevent short circuit and damage the charger.

Matters needing attention

◎ Every time you use, please do not use the battery to the very bottom, and develop the habit of charging the electric vehicle in time.

◎ When the electric vehicle is not used for a long time, the battery should be charged once a month normally, and long-term loss of power is strictly prohibited.

◎ Do not use the charger in the environment of excessive fume, dust, humidity and direct sunlight. Do not turn on the charger when there is thunder and lightning.

◎ If you find that there is an odor, smoke and the shell temperature is too high during the charging process, please cut off the power immediately, stop charging, and send to the sales network or special maintenance station for maintenance.

◎ When charging, please place in a safe place out of reach of children.

◎ In order to protect the ecological environment, users should not dispose of used batteries by themselves, so as not to cause environmental pollution.

6. Correct use and maintenance of the motor

◎ Check whether the screws at both ends of the motor are loose regularly

◎ Check the motor wiring and housing insulation regularly, and whether the connection to the controller is loose.

◎ Heavy load or uphill, such as blocked rotation should immediately reduce the load or get off the vehicle to prevent long-term rotation, damage to the controller or motor.

◎ When the depth of water exceeds 1/3 of the height of the motor, it should be detoured to prevent damage to the motor.

7. Daily maintenance and maintenance

◎ Speed control handle, should be used slowly rotation, avoid excessive force, resulting in accidents and speed control handle life shortened.

◎ When cleaning electric vehicles, do not directly use steam and high pressure water gun rinse. Do not directly pour water on the brake drum motor and the front and rear wheel drums to prevent water from affecting the performance and life.

◎ When brake braking performance is poor, generally only need to adjust the brake line adjustment nut position. When a large adjustment is required, loosen the screw of the rocker arm, adjust it to the normal state, and tighten the nut. When the brake pad wear greatly affects the brake, it should be replaced in time.

◎ If the front and rear brake lines are stuck, they should be cleaned immediately and lubricated to ensure automatic flexibility.

◎ Check whether each tight solid is loose and adjust it in time. The new car should be repaired and maintained within one month from the date of purchase to the sales outlet or special maintenance station.

◎ During the use of the vehicle, maintenance should be carried out frequently, it is recommended that once a month, so as to ensure the best condition of the vehicle, in the front axle, motor shaft, front and rear brake lines and other transmission parts fill lubricating oil. Regular engine oil or butter is recommended.